Filter
Top Products
28 EN
SET BRAND CODE
1
Refer to the chart below. While holding down CABLE/
SAT/DVD on the recorder's remote control, enter one
of the brand code corresponding to the make of your
unit using the NUMBER keys, then press OK.
Check if the unit's power goes off as it should. If it does,
try other operations (੬ step 2).
● Once you have set the remote control to operate the
unit, you don't have to repeat this step until you
replace your remote control's batteries.
● Some brands have more than one code. If the unit
does not function with one code, try entering another.
OPERATE UNIT
2
First, press CABLE/SAT/DVD to set the remote control to
unit mode, then press the corresponding button:
For satellite receiver and cable box . . .
, TV PR +/–, NUMBER keys.
For DVD. . .
, PLAY, STOP, PAUSE, FF, REW,
@#(4¢) keys.
● For some brands of unit, you must press OK after
having pressed the NUMBER keys.
IMPORTANT
Although the provided remote control unit is compatible with
JVC satelite receiver and DVD, as well as many other models, it
may not work with your unit, or in some instances, may have
limited function capability.
NOTES:
●
It's not possible to set the two units at the same time. You can
only set the remote control to operate one of these units at a
time.
●
You have to subscribe to a satellite or cable service to receive
satellite or cable channels.
Multi-brand Remote Control
For satellite receiver, cable box and DVD
Your remote control can operate the basic functions of your
satellite receiver , cable box or DVD.
Before you start . . .
● Turn on the satellite receiver, cable box or DVD using its
remote control.
ATTENTION
The remote control can operate not only the video recorder
but also some of your TV, cable box, satellite receiver and
DVD.
● To operate your video recorder, first press the VCR button
to set the remote control to the Video mode.
● To operate your TV, first press the TV button to set the
remote control to the TV mode.
● To operate your satellite receiver, cable box or DVD, first
press the CABLE/SAT/DVD to set the remote control to
the satellite receiver, cable box or DVD mode.
123
456
7
89
0
1
2
4
3
TV
NUMBER
OK
VCR
STOP
FF
REW
PLAY
@
#
+/–
TV PR+/–
CABLE/SAT/DVD