JVC HR-J271MS VCR User Manual


 
EN 41
QUESTIONS AND ANSWERS
PLAYBACK
Q. What happens if the end of the tape is reached
during playback or search?
A. The tape is automatically rewound to the beginning.
Q. Can the video recorder indefinitely remain in the
still mode?
A. No. It stops automatically after 5 minutes to protect
the heads.
Q. During search, slow, still and frame-by-frame
playback, I can't hear any audio. What's the
problem?
A. This is normal.
Q. When returning from multi-speed search to normal
playback, the picture is disturbed. Should I be
concerned about this?
A. No, it is normal.
Q. Noise bars appear during multi-speed search. What's
the problem?
A. This is normal.
Q. Other than preventing further recording, what effect
does removing the Record Safety tab have?
A. It disables marking of index codes.
Q. Sometimes, during Index Search, the video recorder
can't find the programme I want to see. Why not?
A. There may be index codes too close together.
RECORDING
Q. When I pause and then resume a recording, the end
of the recording before the pause is overlapped by
the beginning of the continuation of recording. Why
does this happen?
A. This is normal. It reduces distortion at the pause and
resume points.
Q. Can the video recorder indefinitely remain in the
Record-Pause mode?
A. No. The video recorder goes to its Stop mode auto-
matically after 5 minutes to protect the heads.
Q. What happens if the tape runs out during recording?
A. The video recorder automatically rewinds it to the
beginning.
TIMER RECORDING
Q. " " and "" remain lit on the display panel. Is there
a problem?
A. No. This is a normal condition for a timer recording in
progress.
Q. Can I program the timer while I'm watching a tape
or a TV broadcast?
A. You won't see the picture as it is replaced by the on-
screen menu, but the audio from the program or tape
you're viewing can be heard.
Q. Is it possible to timer-record a TV programme
broadcast in 2000?
A. Yes, it is possible.
ATTENTION:
This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases,
switch the recorder off and unplug the mains power cord. Then plug it in again and turn the recorder on. Take out the cassette.
After checking the cassette, operate the unit as usual.