JVC HR-J278EU VCR User Manual


 
Filename [HRJ278EU1.fm]
Masterpage:Left
16
EN
RECORDING
Basic Recording
A
Load a cassette.
Insert a cassette with the record safety tab intact.
The recorder’s power comes on automatically and the counter
is reset to 0:00:00.
B
Choose a programme.
On the remote control
Press PR+/– or the NUMBER keys.
On the recorder
Press
9
[PR]. The channel display on the
front display panel starts blinking. While the
display is blinking, press
5
[PR+] or
3
[PR–] to select channel. After about
5 seconds, the channel display stops
blinking.
You can select channel in the stop mode,
Record Pause mode or during forward/reverse
high-speed search.
If no cassette is loaded, or during Record Pause
mode, you can select channel only by pressing
5
[PR+] or
3
[PR–].
If you connect the TV and the recorder only
using the RF connection, press TV/VCR on the
remote control so that the VCR indicator lights
on the front display panel, to view the program
to be recorded.
C
Start recording.
Press and hold
7
and press
4
on the remote control, or
press
7
on the recorder.
If “O.S.D.” is set to “ON” (
pg. 27), “MARK” blinks on the
screen while an index code is being marked.
D
Pause/Resume recording.
Press
9
. Press
4
to resume recording.
E
Stop recording.
Press
8
on the remote control or
0
on the recorder.
Then press
0
to remove the cassette.
Turn on the TV and select the video channel (or
AV mode).
B.E.S.T. takes place at the beginning of the first recording
after inserting the cassette. (
pg. 19)
Accidental erasure prevention
To prevent accidental recording on a recorded cassette,
remove its safety tab. To record on it later, cover the hole
with adhesive tape.
Record safety tab
HRJ278EU1.fm Page 16 Wednesday, March 14, 2001 3:08 PM