Filter
Top Products
38
Edit To Or
From Another
VCR
You can use your VCR as the player or the recorder.
MAKE CONNECTIONS
1
Connect an AV cable (not supplied) between the
player’s VIDEO OUT and AUDIO OUT connectors and
the recorder’s VIDEO IN and AUDIO IN connectors.
● When using your VCR as the recorder and a monaural
VCR as the player, connect the player’s AUDIO OUT
connector to the AUDIO IN L connector on the recorder.
LOAD CASSETTES
2
Insert the playback cassette into the player and the
cassette to be recorded on into the recorder.
SET RECORDER’S INPUT
MODE
3
Set to AUX. With this VCR, press NUMBER key “0” (AU
appears on the front display panel in place of a channel
number).
NOTE:
When using this VCR as the recorder, make sure to
select "FRONT" or "REAR" (depending on which input
connectors you use) at the Aux Input Screen. (To select
the correct AUX input connector, follow steps 4 – 8 from
the "Edit From A Camcorder" section,
੬
pg. 36.)
START PLAYER
4
Set to its play mode.
START RECORDER
5
Set to its record mode.
EDITING (cont.)
Control Two JVC VCRs
The supplied remote control is capable of controlling two
JVC VCRs independently using the A/B CODE switch. You
can set this VCR so it responds to remote commands only
when the switch is set to B, and another VCR so it responds
to commands when the switch is set to A. The switch is
preset to A because this VCR normally responds to A-code
signals. You can easily modify this VCR to accept B-code
commands.
1Unplug the VCR’s power cord from the AC outlet.
2Set the A/B CODE switch on the remote control to B.
3Plug the VCR’s power cord back into the AC outlet.
4Turn the VCR’s power back on by pressing POWER on
the remote.
The VCR will now respond only to B-code commands.
VIDEO OUT AUDIO OUT
VIDEO IN
AUDIO IN
123
456
789
0
123
456
789
0
NUMBER "0"
A/B CODE
POWER
Player
Your VCR
Another VCR
Recorder