Filter
Top Products
38
SPECIAL FEATURES (cont.)
Satellite Receiver Multi-
Brand Remote Control
The VCR's remote control can control functions on the brands
of satellite receivers listed below.
12
45
3
6
8
0
7
9
POWER
ENTER
TURN ON THE SATELLITE
RECEIVER
1
Turn the power on using the satellite receiver’s remote
control.
SET REMOTE CONTROL
MODE
2
Set the TV/CABLE/VCR switch on the VCR’s remote
control to CABLE.
ENTER SATELLITE RECEIVER
BRAND
3
While holding down POWER on the VCR's remote
control, use the NUMBER keys to enter the satellite
receiver brand number from the chart below and then
press STOP.
Follow the example shown at bottom left.
● Once you have set the remote control to operate the
satellite receiver, you don't have to repeat this step
until you replace the remote control's batteries.
OPERATE SATELLITE
RECEIVER
4
First, press POWER to see if the satellite receiver’s
power goes off as it should. If it does, try other
functions (CH5
∞
and the NUMBER keys can be used
to operate the satellite receiver).
● For some brands of satellite receiver, you must press
ENTER after having pressed the NUMBER keys.
● To return the remote to VCR control, set the TV/
CABLE/VCR switch to VCR.
NOTES:
●
Depending on the kind of satellite receiver, there may be
cases where some or all functions cannot be operated using
the remote control.
●
It's not possible to set the remote control for both your cable
box and your satellite receiver at the same time; you can only
set the remote control to the brand of either one.
●
You have to subscribe to a satellite broadcaster to receive
satellite channels.
CH
TV/CABLE/VCR
STOP
NUMBER
(Ex.) To set remote control to RCA 80:
STOP
POWER
8
0
Release
Hold
down
Press in succession
SATELLITE BRAND NAME BRAND CODE
RCA (DSS) 80
SONY (DSS) 81
PRIMESTAR 90