Filter
Top Products
24 EN
G-CODE/SHOWVIEW
12345678
[0 – 9] =
[ ] : DELETE
[PROG] : EXIT
ACCESS G-CODE/
SHOWVIEW SCREEN
1
Press PROG.
ENTER G-CODE NUMBER
2
Press the NUMBER keys to
enter the G-CODE number
of a programme you wish
to record.
● If you make a mistake,
press and input the
correct number.
ACCESS G-CODE
PROGRAM SCREEN
3
Press OK, and the G-CODE
Program screen appears (if
you're just starting out,
"P1" appears).
IMPORTANT
Make sure the channel position number you wish
to record is displayed; if not, see "G-CODE/SHOWVIEW
System Setup" on page 22 and set the Guide
Program number for that G-CODE number correctly.
● If the number you entered is invalid, "ERROR" appears
on the screen. Press and input a valid G-CODE
number.
● If the "G-CODE/SHOWVIEW SETUP" screen appears,
see "ATTENTION – Regarding Guide Program
Number Set" on page 25.
SET TAPE SPEED
4
Press SP/LP/EP ( ) to set the tape speed.
– P1 –
G-CODE/SHOWVIEW123456789
START STOP
21:00 = 22:00
SP
DATE TV PROG
25.04 1
: OK
(HR-J777MS only)
TM
TM
Timer
Programming
Before performing G-CODE/SHOW VIEW Timer Programming:
● Be sure to read "G-CODE/SHOW VIEW System Setup" (੬ pg. 22).
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Turn on the TV and select the VIDEO channel (or AV
mode).
● Select the appropriate colour system by pressing the
COLOUR SYSTEM button (੬ pg. 38).
With the G-CODE System, timer programming is greatly simpli-
fied because each TV programme has a corresponding code
number which your recorder is able to recognise.
TIMER RECORDING (cont.)
G-CODE/SHOWVIEW
[0 – 9] =
[
+/–
] : EXPRESS PROGRAMING
[PROG] : EXIT
123
456
7
89
0
1
2
4
3
OK
NUMBER
SP/LP/EP
PROG
Remember, the clock must be set before you can
programme the timer (੬ pg. 10).
INFORMATION
G-CODE and SHOWVIEW are different trademarks used to
represent the same easy recording feature, but only the term
G-CODE system will be used in the instructions. If you use the
SHOWVIEW system, follow the same instructions listed for
the G-CODE system.