Filter
Top Products
EN 37
123
456
7
89
0
1
2
4
You can use a camcorder as the source player and your video
recorder as the recorder.
Edit From A
Camcorder
MAKE CONNECTIONS
1
Connect the camcorder's AUDIO/VIDEO OUT connec-
tors to the recorder's front panel AUDIO/VIDEO input
connectors.
● Use the L connector for monaural connection.
● When a Master Edit Control-equipped JVC camcorder
is used, the camcorder is capable of controlling the
recorder. Refer to the camcorder's instruction manual
for operating procedure.
SET RECORDER'S INPUT
MODE
2
Press NUMBER key "0" and/or PR+/– so that "F-1"
appears on the display panel.
SELECT "EDIT" FOR PICTURE
CONTROL SET MODE
3
Follow the "Picture Control" section on page 15, then
select "EDIT."
START CAMCORDER
4
Engage its Play mode.
START RECORDER
5
Engage its Record mode.
NOTES:
●
All necessary cables can be obtained from your dealer.
●
You can also use another video recorder as the player instead
of a camcorder.
●
When you select "EDIT" to dub tapes in step 3, be sure to
select "AUTO" (or "NORM" when B.E.S.T. is set to "OFF") after
you finish dubbing the tapes(
੬
pg. 15).
Recorder Your recorder
IMPORTANT:
● To edit, both the player and the recorder must be of the
same colour system. Press your recorder's COLOUR
SYSTEM button to select the appropriate colour system.
● PAL, SECAM and NTSC camcorders can be used as a
player for editing.
● For more information on multi-system compatibility,
੬ pg. 38.
To the remote PAUSE
connector
Editing Cable
(not provided)
AV Cable (not provided)
VIDEO OUT
AUDIO OUT
EDIT
Camcorder
Player
VIDEO IN
AUDIO IN
COLOUR SYSTEM
NUMBER "0"
PR +/–