Filter
Top Products
Filename [HRJ880EU1a.fm]
Masterpage:Left
20
EN
Page 20 May 18, 2001 4:52 pm
PLAYBACK (cont.)
Variable Speed Search
During playback, turn the
JOG
dial to the right for
forward variable-speed search, or to the left for reverse
variable-speed search.
OR
During playback, press
w
or
e
.
● The more times you press, the faster the playback picture
moves.
● To decrease speed, press the button for the opposite direction.
Skip Search
During playback, press
30 SEC
1 to 4 times to skip over
unwanted sections.
Each press initiates a 30-second period of fast-motion
playback. Normal playback resumes automatically.
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. Additional index
codes can be added manually
during playback. (See below.) This
function gives you quick access to
any one of 9 index codes in either
direction.
NOTE:
Before starting, make sure the recorder is in the Stop mode.
Activate Index Search.
Press
w
or
e
(
2
or
6
). “
2
1” or “
6
1” is
displayed on the TV screen and search begins in the
corresponding direction.
● To access index codes 2 through 9, press
w or e repeatedly
until the correct index number is displayed.
Example:
To locate the beginning of B from the current position, press
w
twice.
To locate the beginning of D from the current position, press
e
once.
● When the specified index code is located, playback begins
automatically.
Manual Index Mark/Erase
To mark an index code ...
... during playback press
INDEX MARK
on the recorder.
● The recorder will mark an index code at that location.
● If “O.S.D.” is set to “ON” (
੬
pg. 61), “MARK” blinks on the
screen while an index code is being marked.
To erase an index code ...
... during playback or still press
INDEX ERASE
on the recorder.
● The recorder will fast-forward to the nearest index code and
erase it. Playback continues after the index code is erased.
● If “O.S.D.” is set to “ON” (
੬
pg. 61), “ERASE” blinks on the
screen while an index code is being erased.
NOTES:
● Video Navigation (
੬
pg. 38) may not work properly when an
index code (VISS signal) is marked or erased manually near a
start point of recorded programme.
● During timer-recording you cannot mark an index code
manually.
To resume normal playback, press
4
.
To resume normal playback during a Skip Search,
press
4
.
Current position
Index number
HRJ880EU1a.fm Page 20 Friday, May 18, 2001 4:52 PM