Filter
Top Products
Masterpage:Right
EN
35
Filename [HRJ880EU2.fm]
Page 35 May 31, 2001 10:51 am
REMOTE CONTROL
Remote Control
Functions
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A code
signals because your video recorder is initially set to respond to
A code signals. You can easily modify your video recorder to
respond to B code signals.
A
Set the remote control code.
Press and hold
VCR
on the remote control for over 2
seconds, press the
number key
“
2
” and then press
OK
.
The remote control now can transmit B code signals.
B
Check the remote control code for the
recorder.
Press and hold
4
on the recorder for more than
5 seconds while the recorder is turned off. The code
currently set appears on the front display panel.
C
Change the code for the recorder.
Press any key on the remote control. The recorder will
now only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above, but in step
1
, press the
number
key
“
1
” instead of “
2
”.
PULL/OPEN
PR
PUSH/TURN
24H EXPRESS
HRJ880EU2.fm Page 35 Thursday, May 31, 2001 10:51 AM