JVC HR-S5800AM VCR User Manual


 
EN 31
SET TAPE SPEED
7
Press SP/LP/EP ( ) to set the tape speed.
ACCESS TITLE EDIT SCREEN
8
Press the NUMBER key
“1”. The Title Edit screen
appears.
You can access the Title
Edit screen only when
“PROG. NAVIGATION”
is set to “ON”.
(␣ pg.␣ 38)
ENTER PROGRAMME TITLE
9
Press the NUMBER keys
and PUSH JOG
#
to enter
characters, then press OK.
For details, refer to
“Entering Character” on
page␣ 41.
RETURN TO NORMAL
SCREEN
10
After confirming all information is correct, press PROG
or OK. "PROGRAM COMPLETED" appears on the
screen for about 5 seconds, then normal screen
appears. If “PROGRAM OVERLAPPED” appears on the
screen and “Err” on the display panel, see page 35.
Repeat steps 1 10 for each additional programme.
ENGAGE RECORDER'S
TIMER MODE
11
Press
. The recorder turns off automatically and ""
appears on the display panel.
To disengage the timer, press
again.
NOTES:
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 10, press WEEKLY
(NUMBER key "9") for weekly serials or DAILY (NUMBER key
"8") for daily serials (Monday–Friday). Either "WEEKLY" or
"DAILY" appears on the screen. Pressing the button again
makes the corresponding indication disappear.
You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
pg. 34).
In case of a power failure after programming, the recorder's
memory backup keeps your selections (if the lithium battery is
not exhausted).
WEEKLY
DAILY
SP/LP/EP
OK
PROG
PUSH JOG
NUMBER
– P1 –
25.12 21:00 PR.1
[0–9] : SELECT LETTERS
[
] : DELETE
[
2
/
3
] : CURSOR+=
: OK [PROG] : EXIT
– P1 –
25.12 W 7
[0–9] : SELECT LETTERS
[
] : DELETE
[
2
/
3
] : CURSOR+=
: OK [PROG] : EXIT