Filter
Top Products
60 EN
CORRECTIVE ACTION
Position the camcorder so its
microphone is away from the TV.
Turn the TV's volume down.
If you need the skipped channels,
restore them. (੬ pg. 55)
Press PAUSE to pause the recording,
change channels, then press PLAY to
resume recording.
Perform manual setting again.
Connect the TV aerial cable to the
recorder properly and turn off the
recorder power once, then turn the
recorder power back on again. The
recorder will try Auto Set Up again.
(੬ pg. 8)
Replace the lithium battery with a
new one. (੬ pg. 7)
SYMPTOM
1. Whistling or howling is heard from
the TV during camcorder record-
ing.
2. When scanning channels, some of
them are skipped over.
3. The channel cannot be changed.
4. Channel settings that were made
manually seem to have changed or
disappeared.
5. No channels are stored in the
recorder's memory.
6. "– –:– –" is displayed on the front
display panel after a power outage.
POSSIBLE CAUSE
● The camcorder's microphone is too
close to the TV.
● The TV's volume is too high.
● Those channels have been desig-
nated to be skipped.
● Recording is in progress.
● After the manual settings were
made, Auto Channel Set was
performed.
● The TV aerial cable was not
connected to the recorder when
Auto Set Up was performed.
● The lithium battery is exhausted.
TROUBLESHOOTING (cont.)
OTHER PROBLEMS