JVC HRS6960E VCR User Manual


 
Masterpage:Right-NoTitle0
EN 33
Filename [HRS6960E3-EN.fm]
Page 33 April 22, 2003 3:24 pm
When programmes overlap each other
If “PROGRAM OVERLAPPED” appears, you have another
programme overlapping the programme you have just made.
The Programme Check screen appears and conflicting
programmes will start blinking.
Example: Programme 1 (you have just made) and
Programme 4 overlap each other.
A
Confirm the overlapping programmes.
Overlapping programmes blink on the TV screen.
B
Select the programme to modify.
Press rt, then press OK or e.
You can only select one of the overlapping programmes.
NOTE:
If you do not mind this overlap, press PROG to finish the timer
programme setting. The program starting earlier or program with
the lower program number will be recorded.
C
Cancel or change programme setting.
To cancel a programme, press & when the Programme
screen you do not want is shown. “PROGRAM
COMPLETED” appears on the TV screen for about 5
seconds, then the normal screen appears.
To change a programme, press the appropriate button:
START+/–, STOP+/–, DATE+/–, PR+/–, VPS/PDC
(number key “7”), DAILY (number key “8”), WEEKLY
(number key “9”) and/or SP/LP/EP (
p) when the
Programme screen on which you want to make changes
is shown, then press OK. “PROGRAM COMPLETED”
appears on the TV screen for about 5 seconds, then the
normal screen appears.
NOTE:
If the overlap is not yet solved, or another overlap occurs with
the timer programme setting after making the last correction on a
programme, the conflicting programmes will be shown on the
Programme Check screen again. Repeat the above steps again
until the overlap is solved.
HRS6960E-EN.book Page 33 Tuesday, April 22, 2003 3:24 PM