Filter
Top Products
Filename [HRS6960E5-EN.fm]
Masterpage:Left
56 EN
Page 56 April 22, 2003 3:24 pm
Set Stations (A)
Set station names that are registered in your recorder.
A
Select the item.
Press rt w e until the item you want begins blinking.
B
Access the Manual Channel Set screen.
Press OK twice.
C
Select the new station.
D
Switch the stations.
Press OK.
● The Confirmation screen appears.
● Repeat steps 1 – 4 as necessary.
E
Close the Confirmation screen.
Press MENU.
Set Stations (B)
Set station names other than the ones registered in your recorder.
A
Select the character for station name.
B
Enter the new character.
Press rt to cycle through the characters (A–Z, 0–9, –, f,
+,
I (space) ) and stop when the desired character is
indicated, then press
e to enter. Enter the remaining
characters the same way (maximum of 4). After entering
all characters, press OK.
● The Confirmation screen appears.
● If you make a mistake, press
w until the incorrect character
begins blinking. Then enter the correct character by pressing
rt.
C
Close the Confirmation screen.
Press MENU.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9,
–,
f, +, I (space) (maximum of 4).
Fine-Tuning Channels Already Stored
A
Select the channel to fine-tune.
Press rt w e until the channel you want to tune begins
blinking.
B
Access the Manual Channel Set screen.
Press OK twice. The Manual Channel Set screen appears.
C
Perform tuning.
Press e until “+/–” begins blinking, then press rt until
the picture is its clearest. Then press OK.
● The Confirmation screen appears.
● Repeat steps 1 – 3 as necessary.
D
Close the Confirmation screen.
Press MENU.
Perform steps 1 and 2 of “Manual Channel Set” on page 54
to access the Confirmation screen before continuing.
Press e until the station
name (ID) begins blinking,
then press rt until the new
station’s name (ID) you want
to store begins blinking.
Registered station names
(
੬ pg. 57) appear as you
press
rt.
Perform steps 1 and 2 of “Manual Channel Set” on page 54
to access the Confirmation screen and then perform steps 1
and 2 of “Set Stations (A)” above before continuing.
Press e until the first letter of
the station name begins
blinking.
Perform steps 1 and 2 of “Manual Channel Set” on page 54
to access the Confirmation screen before continuing.
SUBSIDIARY SETTINGS (cont.)
HRS6960E-EN.book Page 56 Tuesday, April 22, 2003 3:24 PM