Filter
Top Products
25
Digital 3R
Digital 3R picture system applies edge correction to the luminance
signal to enhance detail.
ACCESS MAIN MENU SCREEN
1
Press MENU.
ACCESS MODE SET SCREEN
2
Move the highlight bar
(arrow) to "MODE SET" by
pressing %fi, then press
OK or
#
.
SELECT DIGITAL 3R SET MODE
3
Move the highlight bar
(arrow) to "DIGITAL 3R"
by pressing %fi, then press
OK or
#
to set to "ON".
RETURN TO NORMAL SCREEN
4
Press MENU.
NOTES:
●
Normally it is recommendable to keep "DIGITAL 3R" set to "ON".
●
Depending on the type of tape being used, picture quality
may sometimes be better with "DIGITAL 3R" set to "OFF".
MAIN MENU
MODE SET
AUTO CH SET
MANUAL CH SET
INITIAL SET
[
5
∞
] =
[MENU] : EXIT
Digital TBC/NR
Your video recorder is equipped with the Digital TBC (Time
Base Corrector) that removes jitter from fluctuating video signals
to deliver a stable picture even with old tapes and rental
cassettes.
The on/off of Digital 3-DNR (Noise Reduction) which cuts noise
and enables clear picture reproduction is also linked to this
function.
* The default setting is "ON".
We recommend that you use the Digital TBC feature when...
... playing back a tape recorded on a camcorder.
... playing back a tape repeatedly used.
... using this video recorder as the player for editing.
ACTIVATE DIGITAL TBC/NR
1
Press DIGITAL TBC/NR so that the button lights up.
● To turn off DIGITAL TBC/NR, press DIGITAL TBC/NR
again so that the light goes off.
NOTES:
●
If you play back a tape recorded under poor TV reception
condition, there may be cases where the picture becomes
more stable with Digital TBC/NR set to off.
●
When Digital TBC/NR is set to on, if you play back a tape
where certain types of signals are recorded (using a PC or
some character generators), the playback picture may be
distorted. If this is the case, turn off Digital TBC/NR.
MODE SET
B. E. S. T. ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
O. S. D. ON
DIRECT REC ON
AUTO SP=LP TIMER OFF
DIGITAL 3R ON
NEXT PAGE
[5∞] =
[MENU] : EXIT