Filter
Top Products
Filename [HRS7850EU2.fm]
Masterpage:Left
34
EN
Page 34 April 13, 2001 2:55 pm
TIMER RECORDING (cont.)
24 Hour Express
Timer Programming
NOTES:
● You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, “FULL” appears on the front display panel. To record
the extra programme, you must first cancel any unnecessary
programmes (
੬
pg. 35).
● It is not possible to timer-record a satellite broadcast received
on the channel position “0” by the satellite receiver.
● If “Err” appears on the front display panel, repeat the above
steps again.
● When a menu screen is shown, you cannot use 24 Hour
Express Timer Programming function. Press
MENU
to return to
normal screen, and try again.
● You can use 24 Hour Express Timer Programming function
also when the recorder is turned off.
● For 24 Hour Express Timer Programming function, the
programme overlap warning display does not appear even if
some programmes overlap each other. The programme with
the lower programme number will be recorded and the other
one will not be recorded correctly.
You can programme a timer recording that starts within 24 hours
using the JOG dial on the recorder.
A
Enter the programme mode.
Press
24H EXPRESS
#
on the recorder. The start time
indicator ( ) starts blinking on the front display panel.
● The current tape speed and VPS/PDC setting appears on the
front display panel, but it is impossible to change the setting.
You can only change the setting after programming
(
੬
pg. 35).
B
Set the programme start/stop time and
channel.
Turn the
JOG
dial to the left or right to set the time you
want recording to start.
● One click stop of the JOG dial changes the time in 5-minute
intervals.
Push the
JOG
dial. The stop time indicator ( ) starts
blinking on the front display panel. Turn the
JOG
dial to
the left or right to set the time you want recording to stop.
Push the
JOG
dial. Turn the
JOG
dial to the left or right to
select the channel you wish to record.
● You can cancel the setting at any time by pressing and holding
the
JOG
dial for more than 3 seconds or pressing
&
on the
remote control. Repeat the step
2
.
C
Engage the recorder’s timer mode.
Press
24H EXPRESS
#
. The recorder turns off
automatically and
#
appears on the front display panel.
● To disengage the timer mode, press
# (
TIMER
) or
24H EXPRESS
# again.
Before performing the 24 Hour Express Timer
Programming:
● Make sure that the recorder’s built-in clock is set properly.
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Set the tape speed.
HRS7850EU2.fm Page 34 Friday, April 13, 2001 3:02 PM