Filter
Top Products
April 6, 2004 10:11 am Page 6
—6—
Master Page: Right
When you connect the recorder to your TV via a fully-wired
21-pin SCART cable, the following functions are available. You
can use these functions only with a TV offering T-V Link, etc.*
For details, refer to the instruction manual of your TV.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link, DATA LOGIC or NexTView Link via fully-wired
21-pin SCART cable. The degree of compatibility and available functions
may differ by system.
TV Auto Power On
The TV will turn on and be set to its AV mode automatically
whenever you play a tape.
VCR Auto Standby
You can use your TV’s remote control to turn off the recorder.
Direct Rec
You can easily start recording the programme that you are
watching on your TV. When you use this function, set “DIRECT
REC” to “ON” (
੬ 12).
Basic Playback
A Load a cassette
Make sure the window side is
up, the rear label side is facing
you and the arrow on the front of
the cassette is pointing towards
the recorder.
● Do not apply too much pressure when inserting.
● The recorder turns on, and the counter is reset, automatically.
● If the cassette’s record safety tab has been removed, playback
begins automatically.
B Start playback
Press 4.
T-V Link Functions Playback
Turn on the TV and select the video channel or AV mode.
During playback
Stop playback
Press 8 on the remote
control.
OR Press 0 on the recorder.
Pause playback and view still picture
Press 9.
● Press 4 to resume normal playback.
● If there is vertical jitter, press PR r/t on the remote control or
PR +/– on the recorder to correct the picture.
Pause and Frame-by-Frame playback
Press 9 to pause, then press e or 9 repeatedly.
● Press 4 to resume normal playback.
Picture Search
Press 3 or 5. Press 3 or 5 again to perform high-
speed search.
● Each time you press 3 or 5, the search speed changes
between low-speed and high-speed.
● Press 4 to resume normal playback.
Variable Speed Search (including slow-motion)
Press w or e repeatedly.
● Press 4 to resume normal playback.
● Each time you press w or e, the playback speed changes. To
decrease the speed during picture search, press the opposite
direction button repeatedly.
● During still picture, press and hold e to start forward slow
motion playback. When you release the button, still picture
resumes. During still picture, holding 9 for more than
2 seconds also starts forward slow motion playback. If you
press 9 again, still picture resumes.
● During slow motion playback, some noise may appear on the
TV screen. Press PR r/t on the remote control or PR +/– on
the recorder to eliminate the noise.
Reverse
search
3steps
Reverse
play
Slow
motion
1step
Normal
play
Forward
search
4steps
Forward
Reverse
HR-V510_001EN.fm Page 6 Tuesday, April 6, 2004 10:11 AM