JVC HR-V610AA VCR User Manual


 
Page 2 June 11, 2004 11:45 am
—2—
G-
CODE
and S
HOW
V
IEW
are different trademarks used to represent
the same easy recording feature. However, for simplicity, only the
term G-
CODE
will be used in the instructions. If you use
S
HOW
V
IEW
system, follow the same steps listed for the G-
CODE
system (For HR-V610AG and HR-V610AJ only).
When the equipment is installed in a cabinet or a shelf, make sure
that it has sufficient space on all sides to allow for ventilation
(10 cm or more on both sides, on top and at the rear).
When discarding batteries, environmental problems must be
considered and the local rules or laws governing the disposal of
these batteries must be followed strictly.
Failure to heed the following precautions may result in damage
to the recorder, remote control or video cassette.
1. DO NOT
place the recorder ...
... in an environment prone to extreme temperatures or
humidity.
... in direct sunlight.
... in a dusty environment.
... in an environment where strong magnetic fields are
generated.
... on a surface that is unstable or subject to vibration.
2. DO NOT
block the recorder’s ventilation openings or holes.
(If the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able to get out.)
3. DO NOT
place heavy objects on the recorder or remote
control.
4. DO NOT
place anything which might spill on top of the
recorder or remote control.
(If water or liquid is allowed to enter this equipment, fire or
electric shock may be caused.)
5. DO NOT
expose the apparatus to dripping or splashing.
6. DO NOT
use this equipment in a bathroom or places with
water. Also DO NOT place any containers filled with water or
liquids (such as cosmetics or medicines, flower vases, potted
plants, cups, etc.) on top of this unit.
7. DO NOT
place any naked flame sources, such as lighted
candles, on the apparatus.
8. AVOID
violent shocks to the recorder during transport.
MOISTURE CONDENSATION
Moisture in the air will condense on the recorder when you move
it from a cold place to a warm place, or under extremely humid
conditions—just as water droplets form on the surface of a glass
filled with cold liquid. Moisture condensation on the head drum
will cause damage to the tape. In conditions where condensation
may occur, keep the recorder’s power turned on for a few hours to
let the moisture dry.
How to use the remote control
The remote control can operate most of your recorder’s functions,
as well as basic functions of TV, cable box, satellite receiver, and
DVD sets of JVC and other brands.
Point the remote control toward the sensor window on the
target component.
The maximum operating distance of the remote control is about
8m.
NOTES:
When inserting the batteries, be sure to insert in the correct
directions as indicated under the battery cover.
If the remote control does not work properly, remove its batteries,
wait for a few seconds, replace the batteries and then try again.
Video heads cleaning
The heads get dirty in the following cases:
in an environment prone to extreme temperature or humidity
in a dusty environment
flaw, dirt or mold on video tapes
continuous usage for a long time
Use a dry cleaning cassette — TCL-2 — when:
Rough, poor picture appears while a tape is played back.
The picture is unclear or no picture appears.
“USE CLEANING CASSETTE” appears on the screen (only with
“O.S.D.” set to “ON” (
10)).
Buttons, Connectors
and Indicators
Front Panel
Rear Panel
ATTENTION
To mobile phone user:
Using a mobile phone in the vicinity of the recorder may cause
picture vibration on the TV screen or change the screen to a
blue back display.
On placing the recorder:
Some TVs or other appliances generate strong magnetic fields.
Do not place such appliance on top of the recorder as it may
cause picture disturbance.
Cassette
loading slot
VIDEO/AUDIO
input connectors
Display panel
Play indicator
Record
indicator
Timer mode indicator
Channel and auxiliary input/Clock time
REC LINK indicator
REVIEW indicator
Pause 9 [REC LINK]
Play 4
Rec 7
Stop/Eject
0
5 Forward
PR+/–
1
3
Rewind
To access covered connectors, pull and open the connector cover.
Mains power cord
Lithium battery
compartment
HR-V610AA.AG.AJ_EN_B.fm Page 2 Friday, June 11, 2004 11:45 AM