JVC HR-XV32E DVD VCR Combo User Manual


 
Filename [XV3EX_09Editing.fm]
Masterpage:Left0
58 EN
Page 58 August 22, 2003 12:20 pm
REMOTE CONTROL
Remote Control Functions
Remote A/B/C/D Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four
codes (A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
On the remote control
Keep pressing VCR down during steps A B.
A
Change the remote control code.
Press the number key “1” for A, “2” for B, “3” for C or
“4” for D.
B
Set the remote control code.
Press OK to set the code.
On the unit
C
Turn off the unit.
Press 1.
D
Display the code.
Press 4 on the unit for over 5 seconds while the unit is
turned off. The code currently set appears on the front
display panel.
If the code displayed on the front display panel is different
from the code set on the remote control, go to step E.
E
Change the unit’s code.
Press 8 on the remote control. The code currently set on
the remote control will be applied to the unit.
NOTE:
When “POWER SAVE” is set to “ON” (pg. 64), it is
impossible to change the remote code.
Before performing the following steps:
Slide the TV/VCR/DVD switch to the right.
XV3EX_01.book Page 58 Friday, August 22, 2003 12:21 PM