JVC HR-XVC19BUS DVD Player User Manual


 
37
Reference
Symptom
The DVD+VCR does
not start playback.
Video tape cannot be
inserted.
No Hi-Fi sound
The Remote Control
does not work
properly.
Camcorder image is
not shown.
Camcorder image via
AV input to
DVD+VCR is not
shown on TV screen.
Timer recording is not
possible.
Cause
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the
guide.
The disc is dirty.
Is the cassette compartment
empty?
Audio mode is not set properly.
There is an obstacle in the path of
the Remote Control and this unit.
The batteries in the Remote Control
are exhausted.
The Remote Control is not pointed
at the remote sensor of the
DVD+VCR.
The Remote Control is too far from
the DVD+VCR.
This Remote Control use the same
buttons for VCR and DVD functions
(ex.PLAY).
The Remote Control of a JVC TV or
Receiver cannot operate the DVD+
VCR.
Camcorder is off.
DVD+VCR SOURCE SELECT is
not set to LINE1 or LINE2.
Clock in DVD+VCR is not set to
correct time.
Timer has been programmed
incorrectly.
indicator light does not appear
after programming timer.
Correction
Insert a playable disc. (Check the
disc type and Regional code.)
Place the disc with the playback side
down.
Place the disc on the disc tray cor-
rectly inside the guide.
Clean the disc.
Eject the tape in.
Select STEREO by repeatedly
pressing A.MONITOR on the
Remote Control.
Remove the obstacle.
Replace the batteries with new ones.
Point the Remote Control at the
remote sensor of the DVD+VCR.
Operate the Remote Control within
23ft (7m).
When using a VCR, first press the
VCR button. When using a DVD, first
press the DVD button.
Use the DVD+VCRs Remote
Control.
Turn camcorder on and operate
properly.
Press AUX to select LINE input
channel (LINE1 or LINE2).
Set clock to correct time.
Reprogram Timer.
Reprogram Timer and turn
DVD+VCR off to enable timer.
H◗❇✵✼❆❚❘✵✽❘❚❘✸✲✵✤✤✴✹✲✺✲✵✸✤✤✵✵✾✴✻✤❅M✤✤y✷