JVC HR-XVC32SUJ DVD VCR Combo User Manual


 
22
Timer Recording (continued)
Check, cancel and change programs
~ Disengage the timer mode.
Press TIMER, then press POWER.
Ÿ Access the Program
Check screen.
Press PROG. CHECK.
! Access the Program
screen.
Press PROG. CHECK again to
check more information.
Each time you press PROG.
CHECK, the next program’s
information appears.
To cancel or change a program
Cancel or change a program.
Press CANCEL to cancel a program. To change
program settings, press the appropriate button: START
+/–, STOP +/–, DATE +/–, CH +/–, DAILY (number
button “8”), WEEKLY (number button “9”) and/or
SP/EP.
@ Return to the normal screen.
Press PROG. CHECK as many times as necessary.
If there are still some programs remaining, go on to
step ¤.
¤ Return to the timer mode.
Press TIMER.
When programs overlap each other
If “PROGRAM NOT COMPLETED PROGRAM
OVERLAP” appears, you have another program
overlapping the program you have just made.
The Program Check screen appears and conflicting
programs will start blinking.
Example: Program 1 (you have just made) and
Program 4 overlap each other.
~ Confirm the overlapping programs.
Overlapping programs blink on the TV screen.
Ÿ Select the program to modify.
Press %fi, then press ENTER.
• You can only select one of the overlapping programs.
NOTE:
If you do not mind this overlap, press PROG to finish the timer
program setting. The program with the lower program number
will be recorded and the other one will not be recorded
correctly. If no changes are made for approximately 1 minute,
the unit will return to the normal screen.
! Cancel or change program setting.
To cancel a program, press CANCEL when the
Program screen you do not want is shown. “PROGRAM
COMPLETED” appears on the TV screen for about 5
seconds, then the normal screen appears.
To change a program, press the appropriate button:
START +/–, STOP +/–, DATE +/–, CH +/–, DAILY
(number button “8”), WEEKLY (number button “9”)
and/or SP/EP when the Program screen on which you
want to make changes is shown, then press ENTER.
“PROGRAM COMPLETED” appears on the TV screen
for about 5 seconds, then the normal screen appears.
NOTE:
If the overlap is not yet solved, or another overlap occurs with
the timer program setting after making the last correction on
a program, the conflicting programs will be shown on the
Program Check screen again. Repeat the above steps again
until the overlap is solved.
20-23_HR-XVC32SUJ.indd 2220-23_HR-XVC32SUJ.indd 22 05.4.21 6:31:02 PM05.4.21 6:31:02 PM