Filter
Top Products
Masterpage:Right-No-Heading
EN
81
Filename [XVC33UM_10Subsidiary.fm]
Page 81 4 August 2003 6:42 pm
Others Settings
* The default setting is
bold
in the table below.
Playback discs
Output
STREAM/PCM DOLBY DIGITAL/PCM PCM ONLY
DVD VIDEO with
48 kHz, 16/20/24 bit linear
PCM
48 kHz, 16 bit linear PCM
DVD VIDEO with DTS DTS bitstream 44.1 kHz, 16 bit stereo linear PCM
DVD VIDEO with Dolby
Digital
Dolby Digital bitstream
48 kHz, 16 bit stereo linear
PCM
Audio CD/Video CD 44.1 kHz, 16 bit stereo linear PCM
Audio CD with DTS DTS bitstream 44.1 kHz, 16 bit stereo linear PCM
MP3 disc Linear PCM
NOTES:
●
The unit is not equipped with the DTS decoding function.
●
When you play back a DVD VIDEO or Audio CD disc with DTS, use a DTS decoder to get correct signals from your speakers.
Never use the unit’s analog output connectors, which output incorrect signals that may damage your speakers.
●
If you connect the analog outputs and digital outputs simultaneously, be sure to select the source of the amplifier correctly, or
set the level control of the amplifier connected to the analog outputs to minimum.
8
RESUME
ON
OFF
DISC RESUME
When this function is set to “ON”, you can use the resume function.
(
੬
pg. 45)
ON
: You can start playback from the resume point of the
placed disc.
OFF
: You cannot use the resume function.
DISC RESUME
:
The unit retains a memory of the resume points of
the last 30 discs played back, even though they
have been ejected.
NOTE:
This function is not available for Audio CDs and MP3 discs.
8
ON SCREEN GUIDE
ON
OFF
When this function is set to “ON”, the unit can display “on-screen
guide” icons or characters which shows the conditions of the unit or
disc.
XVC33UM_01.book Page 81 Monday, August 4, 2003 7:24 PM