JVC AV 32260 CRT Television User Manual


 
Connections
16
S VIDEOVIDEO
INPUT
1
R
L MONO
INPUT
4
AUDIO
OVER
R
L
75
(VHF / UHF)
COMPONENT
VIDEO IN
AV COMPULINK EX
AUDIO OUT
VCR or DVD player
AV
Compu
Link EX
Swap
To Connect: Plug one end of the AV Compu Link cable into the AV Compu Link EX input on your VCR,
DVD, or other Compu Link device. Plug the other end of the AV Compu Link EX cable into the AV
Compu Link input at the rear of the television.
Connecting to JVC AV Compu Link
JVC’s AV Compu Link EX feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded tape* into your AV Compu Link EX compatible JVC-brand VCR or DVD into
your JVC DVD player and the device will automatically turn on and begin playback. At the same
time, using the AV Compu Link, the VCR or DVD player sends a signal to the television telling it
to turn on and switch to the proper video input.
• The AV Compu Link cable may be included with the JVC AV Compu Link accessory you wish to
connect. If it is not, contact an authorized JVC Service Center for part # EWP 805-012.
• AV Compu Link can only be used with JVC-brand products.
NOTES:
* In order for the VCR playback to begin automatically, the recording tab must be removed from the
VHS tape. If the tab is in place, automatic switching will occur when you push the VCR’s P
LAY button.
• The AV Compu Link cable has a male 3.5 mm (mono) plug on each end.
• If your JVC-brand VCR has “A Code/B Code Remote Control Switching” (see your VCR’s user’s guide),
using VCR A Code will switch the TV to input 1.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see the HiFi’s
connection instructions in its user’s guide for detailed connection information.
• AV COMPU LINK EX is compatible with the following receivers: RX-664V, RX-665V, RX-668VBK,
RX-774V, RX-778VBK, RX-884V, RX-888VBK, RX-1024V, RX-1028VBK, and later receiver models.