EN 57
Audio dubbing replaces the normal audio sound of a previously
recorded tape with a new soundtrack. Use your VCR as the
recorder.
Audio Dubbing
MAKE CONNECTIONS
1
Connect an audio component to the AUDIO IN L + R
connectors on the VCR's front panel. *When connect-
ing monaural equipment, use only the VCR's AUDIO
IN L connector.
SET INPUT MODE
2
Press the remote control's NUMBER key "0" and CH so
that "F-1" appears in place of a channel number.
● Be sure to select "FRONT S-VIDEO" or "FRONT
VIDEO" at the AUX Input Screen. (To select the correct
AUX input connector, follow steps 4 – 6, 15 from the
"Edit From A Camcorder" section, ੬ pg. 54.)
LOCATE START POINT
3
Press PLAY to start playback of the tape in your VCR,
and press PAUSE when you find the point where you
want to start dubbing.
ENGAGE AUDIO DUBBING
4
Press A. DUB.
● Your VCR enters the Audio Dubbing Pause mode.
( blinks, and light up on the front display
panel.)
START DUBBING
5
Engage the audio component's Play mode, then press
PLAY to start the tape in your VCR. Audio dubbing
begins at this point.
● blinks and is displayed on the front display
panel.
● To stop dubbing temporarily, press PAUSE. Press
PLAY to resume dubbing.
END AUDIO DUBBING
6
Press STOP to stop the tape in your VCR, and engage
the audio component's Stop mode.
Pre-recorded tape
Audio-dubbed tape
Normal audio track
Video/Hi-Fi audio
track
Audio cable
Audio component
(CD player etc.)
NOTES:
●
When monitoring the sound during Audio Dubbing, the
normal soundtrack is automatically selected. If you wish to
hear the Hi-Fi or mixed sound (Hi-Fi + Normal soundtracks),
refer to the "Select The Soundtrack" section (
੬
pg. 30) and
select the soundtrack you wish to hear.
●
Audio dubbing stops automatically when the counter reaches
"0:00:00", and the VCR enters the Play mode. Check the
counter reading before dubbing.
●
Audio dubbing is also possible using the rear AUDIO IN
connectors. When using these connectors, be sure to select
"REAR S-VIDEO" or "REAR VIDEO" at the Aux Input screen.
To select the correct Aux Input connector, follow steps 4 – 6,
15 from the "Edit From A Camcorder" section
੬
pg. 54.
●
Audio dubbing cannot be performed on a cassette that has
had its record safety tab removed.
●
When playing back an audio-dubbed tape, refer to the "Select
The Soundtrack" section (
੬
pg. 30) to select the soundtrack
you wish to hear.
●
Picture may be distorted during Audio Dubbing Pause.
●
It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
PAUSE
