Filter
Top Products
25
ENGLISH
Changing the level indicator mode
When shipped from the factory, the level indicator on the display shows the audio level
setting.
You can change it by following the procedure below.
• AUDIO: Audio level indicator
• ANTENNA: Tuner sensitivity indicator
• OFF: Volume setting indicator
Level indicator
“ANT” lights up when the indicator
mode is set to tuner sensitivity.
1. Press the SEL button for more than 2 seconds to set the preferred setting mode (see
page 23).
2. Select “LEVEL” with the SEL button.
Turning on/off the key-touch tone
You can deactivate the key-touch tone if you do not want to make it beep when you press a
button. When shipped from the factory, the key-touch tone is activated.
• ON: Activates the key-touch tone.
• OFF: Deactivates the key-touch tone.
1. Press and hold the SEL (Select) for more than 2 seconds to set that “PSM” appears on
the lowerpart of the display.
2. Select “BEEP” with the SEL button.
3. Press +/– to select the setting you want to use.
Each time you press the button, the setting changes as follows:
Notes:
• Key-touch tone comes out of the front speakers only. If you have only rear speakers connected in your
car, no key-touch tone comes out.
• If you have connected an external amplifier, key-touch tone sounds louder. In this case, adjust the
volume control of the connected amplifier.
3. Press +/– to select the level indicator mode you want to use.
Each time you press the button, the level indicator mode changes as follows:
AUDIO
ANTENNA
OFF
Current setting appears.
Current setting appears.
OFF
ON
EN 21-27 KS-FX833R[E]/f 98.8.19, 3:19 PM25