Filter
Top Products
97
Additional information
Additional
information
XV-D701BK [C] EN
LET0141-002A
English
Français
Troubleshooting
What appears to be a malfunction may not always be serious. Please go through the following list before requesting
service.
Symptom
Power does not come on.
Remote control does not work.
No picture is displayed on the
monitor.
Picture is noisy.
No audio is reproduced.
No sound from headphones.
Sound is distorted or noise is
generated.
Picture is garbled.
Picture does not fit with the
television screen.
Operation is not possible
Possible case
Power plug is not inserted securely.
Too far from the unit.
The tip of the remote unit is not
pointed in the right direction.
Batteries are exhausted.
Battery polarity is incorrect.
Connection of video cable is
incorrect.
Input selection of TV is incorrect.
Disc is not playable.
The unit is connected to a VCR
directly and the copyguard function
is activated.
Connection to stereo system is
incorrect.
Input selection of amplifier is
incorrect.
The unit is connected only using
DIGITAL OUT jack.
PHONES LEVEL is too low.
Disc is dirty.
The screen saver mode is set to
MODE 1, and the screen saver
function is activated.
MONITOR TYPE is not correctly set.
Television is not correctly set.
Microcomputer malfunctions due to
lightning or static electricity.
Moisture condensation occurs by a
sudden change of temperature or
humidity.
Remedy
Plug in securely.
Come closer to the unit.
Point the infrared light- emitting window
toward the remote sensor on the front panel.
Replace the batteries with new ones.
Take out the batteries and insert them again
in the correct direction.
Connect the cable correctly.
Select correctly.
Use a playable disc. (See page 13.)
Connect the unit so that the picture signal
flow directly to the TV.
Check connections.
Select correctly.
Connect the unit using AUDIO OUT jack also.
Adjust the PHONES LEVEL.
Wipe the disc surface.
Set the screen saver mode to the other mode.
Select monitor type correctly. (See page 55).
Set the television correctly.
Turn off the power and unplug the power
cord, then connect the power cord again.
Turn off the power, then turn it on a few
hours later.