Filter
Top Products
47
The Synchro Editing function synchronizes the start of the
playback and recording operations when starting an edit
operation using a camcorder equipped with a LANC connector
and your video recorder.
Synchro Editing
MAKE CONNECTIONS
1
Connect your recorder to camcorder (੬ pg. 46), and
connect your recorder's SYNCHRO EDIT connector to
the camcorder's LANC connector.
SET RECORDER'S INPUT
MODE
2
Press AUX and/or PR to select "F-1" for the AUDIO/
VIDEO input connectors, or "S-1" for the AUDIO/
S-VIDEO input connectors, depending on the connec-
tors being used.
SET EDIT MODE
3
See "Picture Control" on page 45.
LOCATE START POINT
4
Start playback of the tape in the camcorder, and pause
playback when you find the point where you want to
start editing. Press and hold PAUSE and press RECORD
on your recorder so that the recorder enters the Record-
Pause Mode.
START SYNCHRO EDITING
5
Press SYNCHRO ¶/¶8.
PAUSE SYNCHRO EDITING
6
Press SYNCHRO ¶/¶8 again.
● Repeat steps 4 – 6 as necessary.
NOTES:
●
The Synchro Edit function may not work with the initial part
of a camcorder tape.
●
The Synchro Edit function cannot be used when using the JLIP
function. (Pressing SYNCHRO
¶
/
¶8
cancels the JLIP
function.)
●
The Synchro Editing function may not work properly with
some type of camcorder.
●
The Synchro Editing function enables the recorder to control a
camcorder which has a LANC connector. It is not possible to
control the recorder by a camcorder, even though the
camcorder has a LANC connector.
●
When you select EDIT to dub tapes in step 3, be sure to select
AUTO (or NORM when B.E.S.T. is set to OFF) after you finish
dubbing the tapes.
LANC Cable
(not provided)
Camcorder
Recorder
SYNCHRO EDIT
connector
Player
To LANC connector
1 2 3
4 5 6
7 8 9
1
2
1
2
3
– –:– –
0
3
4
4
PR
AUX
PAUSE
RECORD