Filter
Top Products
Masterpage:Right-NoTitle0
EN
47
Filename [SR-VS30E_3-EN.fm]
Page 47 February 1, 2002 3:27 pm
Normal Dubbing
(from VHS to DV)
NOTES:
●
If you set the dubbing direction incorrectly, you could erase an
important recording that you wanted to copy. It is
recommended to conduct a test with unimportant cassettes
first.
●
There may be a discrepancy of several seconds between
where you intend editing to start, and where it actually starts.
●
The superimposed indication during the operation or dubbing
is not recorded.
●
To cancel the dubbing mode, press
PR +/–
so that the dubbing
direction indicator ( VHS) goes off.
●
Before you start dubbing, set “SOUND MODE” to the
appropriate mode. (
੬
pg. 73)
You can dub selected scenes on a tape, starting and stopping
wherever you wish.
A
Load cassettes.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the record safety
tab removed.
For the DV deck
Insert a Mini DV cassette with the erase protection switch
set to “REC”.
B
Select the dubbing direction.
Press .
● The dubbing direction indicator ( VHS) lights.
C
Set the tape speed.
Press
DV
, then press
SP/LP (
p
)
.
● “DV }
VHS” appears on the TV screen if “O.S.D.” is set to
“ON”. (
੬
pg. 69)
D
Locate the start point on the VHS deck.
A
Press
VHS
.
B
Press
4
to start playback.
C
Press
9
to pause playback a little before the start
point.
E
Prepare the DV deck for dubbing.
A
Press
DV
.
B
Press and hold
9
and press
7
so that the DV deck
enters the Record Pause mode.
● VHS playback indicator and DV recording indicator light.
F
Start dubbing.
Press
START
.
G
Pause dubbing.
Press
START
.
● The DV deck enters the Recording Pause mode, then the VHS
deck enters the Dubbing Pause mode.
H
End dubbing.
Press
8
to stop recording on the DV deck. Then press
VHS
and press
8
to stop playback on the VHS deck.
123
456
789
1
2
1
2
3
0
3
4
4
1
32
SR-VS30E_1-EN.book Page 47 Friday, February 1, 2002 3:35 PM