JVC LPT0827-001B DVR User Manual


 
Filename [DR-M1EK_08Recording.fm]
Masterpage:Left+
Page 58 August 15, 2003 7:53 pm
TIMER RECORDING (cont.)
58
Manual Timer
Programming
You can programme this unit to timer-record as many as
8 programmes.
If you do not know the PlusCode number for the programme you
wish to record, use the following procedure to set your unit to
timer-record the programme.
A
Load a disc.
A
Press
x
to open the disc tray.
B
Place a recordable disc on the disc tray.
For details, refer to “Placing a Disc” (
pg. 10).
C
Press
x
to close the disc tray.
B
Access Programme Check screen.
C
Access the programme screen.
D
Enter the recording date.
Press
rt
repeatedly to set the desired date.
The current date appears on the TV screen. The date you enter
appears in its place.
E
Enter the recording start time.
Press
we
to select “START”, then press
rt
repeatedly
to set the desired start time.
Each press of
rt
advances/goes back the start time in 1-min.
increments.
To advance/go back the start time in 30-min. increments, press
and hold
rt
.
Before performing Manual Timer Programming:
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the
TV/CABLE/SAT/DVD
switch to
DVD
.
Make sure that the unit’s built-in clock is set properly.
Press
PROG/CHECK
.
When “PROGRAMME FULL
DELETE UNWANTED TIMER
PROGRAMME” appears on
the TV screen, you need to
cancel some of the reserved
programmes. (
pg. 63)
Press
rt
repeatedly to
select “NEW TIMER
PROGRAMME”, then press
ENTER
.
DR-M1EK_01.book Page 58 Friday, August 15, 2003 7:53 PM