Filter
Top Products
- 11 -
the TV out socket located at the devices (VCR,
DVB etc.) to this socket as well.
How to connect other devices
IMPORTANT: Switch off the TV before connect-
ing any external device.
Sockets for external connections are at the
back of the TV. For connection of other devices
via Euroconnector refer to the manuals of the
related devices.
Inserting batteries in the remote
control handset
Remove the battery cover located on the back
of the handset by gently pulling upwards from
the indicated part.
Insert two AA/R6 dry cell or equivalent type of
batteries inside.
Replace the battery cover.
NOTE: Remove the batteries from remote con-
trol handset when it is not to be used for a long
period.Otherwise it can be damaged due to
any leakage of battery.
Old batteries must be disposed in a desig-
nated area. If performance of the remote con-
trol reduces, replace the batteries with the cor-
rect type. Do not combine a used, old battery
or a new one or mixed battery types. Remove
dead batteries immediately to prevent acid
from leaking into the battery compartment.
Switching the TV ON/OFF
To switch the TV on
Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Then the TV switches itself to stand-
by mode and the power lamp becomes red
located on the front of the TV.
2- To switch on the TV from stand-by mode
either:
Press the
button on the remote control or
on the right side of the TV
or.
press a digit button on the remote control so
that a programme number is selected,
or,
Press P/Ch buttons on the right side of the
TV or press
or buttons on the
remote control, so that last switched off
programme is selected.
By either ways the TV will switch on and the
power lamp will become green.
To switch the TV off
Press the button on the remote control
or on the right side of the TV, so the TV will
switch to stand-by mode and the power lamp
will become red.
NOTE: To switch the TV off completely remove
the mains plug from the socket.
JVC LT-17C88SJ-50058783.p65 15.02.2005, 13:4811