Filter
Top Products
- 23 -
PC Mode
Installation
Power off both Computer and Display before
making any connections.
Set your PCs resolution correctly before con-
necting to the TV. See the table in page 30 for
supported modes.
Use a D-SUB cable to connect the TV's PC
input to the computer's RGB output terminal.
If you want to listen to the sound from the
computer, use an audio cable to connect the
PC AUDIO IN to the computer's sound out-
put terminal.
Tighten the screws of the Display cable until
the connectors are fastened securely (fin-
ger-tighten only).
Main Menu in PC mode:
Enter the main menu by pressing the MENU
button on the remote control.
PC Picture Position Menu:
In the Main menu, select PC Picture Posi-
tion using or button, then enter the
menu pressing / or OK buttons..
Auto Position
If you shift the picture horizontally or vertically
to an unwanted position, use this item to put
the picture into correct place automatically.
Select Auto position item by using
or
buttons.
Press OK button.
Press MENU button or BACK button to store
the value.
Warning: Auto position adjustment recom-
mended to be done with the full screen image
for the proper adjustment.
Horizontal Position
This item shifts the image horizontally to right
hand side or left hand side of the screen.
Select Hor. Position item by using
or
button.
Use
or button to adjust the value.
Press MENU button or BACK button to store
the value.
Vertical Position
This item shifts the image vertically towards
the top or bottom of the screen.
Select Ver. Position item by using
or
button.
Use or button to adjust the value.
Press MENU button or BACK button to store
the value.
Dot Clock
Dot Clock adjustments correct interference
that appear as vertical banding in dot inten-
sive presentations like spreadsheets or para-
graphs or text in smaller fonts.
Use
or button to adjust the value.
Clock Phase
Depending on the resolution and scan fre-
quency that you input to the TV Set, you may
see a muddy or noisy picture on the screen. In
such a case you can use this item to get a
clear picture by trial and error method.
Use
or button to adjust the value.
JVC LT-17C88SJ-50058783.p65 15.02.2005, 13:4923