JVC LT-20A60SU Flat Panel Television User Manual


 
ENGLISH - 16 -
 Press   or   button to select Noise
Reduction level Off or Minimum or Me-
dium or Maximum
Note 1:
At low signal level, the changings on the Noise Reduction
function are not effective when there is menu on the screen.
If the menu is removed, the effect of this function is seen. At
normal broadcasting, Noise Reduction changings are effec-
tive at once.
Note 2:
At moving pictures, while Noise Reduction is at maximum
level, some picture distortions may occur. If Noise Reduc-
tion is set to medium or minimum, the picture will improve.
Setting Hue
During Playback NTSC system, this will ap-
pear in AV mode only when NTSC video source
is applied. Otherwise, HUE option is invisible
in Picture menu in TV mode :
 Using 
 or   button select Hue.
 Press   button to increase hue level.
 Press 
 button to decrease hue level.
Reset
Press BLUE button to reset the picture modes
to factory default settings.
To Store the Settings
In the Picture Menu, all settings are stored
automatically.
Sound Menu
To change sound settings
As you enter the main menu, sound will be
the second item. In the main menu, select
Sound using 
 or   button, then enter
the sound menu pressing   /   or OK
button.
Setting Volume:
As you enter the sound menu, Volume will be
the first selected option.
 Press 
 button to increase volume.
 Press   button to decrease volume.
Or you can directly change the volume set-
tings using 
+ (to increase) or -  (to
decrease) button.
Setting Bass Level
 Using 
 or   button select Bass Level.
 Press   button to increase bass level.
 Press 
 button to decrease bass level.
Setting Treble Level
 Using 
 or   button select Treble
 Press 
 button to increase treble level.
 Press   button to decrease treble level
Setting Balance
It allows adjusting the distribution between the
left and right speakers.
 Using 
 or   button select Balance.
 Press   button to change balance right-
ward.
 Press 
 button to change balance leftward.
Hyper Sound
 Using 
 or   button select Hyper Sound
 Pressing   or   button will turn on or off
this feature.
Pseudo/spatial effect can be turned on or off
via the Hyper Sound item in the Sound menu
or by remote control. In Mono transmission
the left and right channels will be added at left
channel and dummy stereo effect will intro-
duced to end-user.
In stereo transmission it yields a phase differ-
ence between left and right channels. Hyper
Sound selection will be displayed on the
screen when the TV Status button is pressed
or programme is changed.
To Change Audio Out Settings
Audio Out is a sub-menu of Sound menu.
LT_20A60_SU.p65 31.08.2005, 08:1716