Filter
Top Products
- 14 -
Step 6: Switching the TV ON/OFF
To switch the TV on
Your TV will switch on by two steps:
1- Connect the power supply cord to the sys-
tem. Then the TV switches itself to stand-
by mode and the power lamp becomes
red located on the front of the TV.
2- To switch on the TV from stand-by mode
either:
Press the
,
button on the remote control
or on the right side of the TV
or.
press a digit button on the remote control so
that a programme number is selected,
or,
Press
or buttons on the right
side of the TV or on the remote control, so that
last switched off programme is selected.
By either ways the TV will switch on and the
power lamp will become green.
To switch the TV off
Press the
,
button on the remote con-
trol or on the right side of the TV, so the TV
will switch to stand-by mode and the power
lamp will become red.
NOTE: To switch the TV off completely remove
the mains plug from the socket.
Step 7: Initial settings
When the TV is first turned on, it goes into the
initial settings mode. Follow the instructions
on the screen display to make the initial set-
tings.
Note: If the TV does not go into the initial settings mode this
is because your TV has already been turned on for the first
time. (Perform the initial settings with INSTALLATION (see
page 25) in the DTV menu and AUTO STORE (Analogue)
(see page 32) in the PROGRAM menu.)
Because this is the first time that IDTV has
been used, there are no channels stored in
the memory and below information will be dis-
played on the screen.
1. Press the OK button to start the automatic
search.
The IDTV will automatically tune to the UHF
transmission channels 21 to 68 looking for
digital terrestrial TV broadcasts and display-
ing the names of channels found. This pro-
cess will take about five minutes. To cancel
searching, you can press MENU button at any
time during the process.
HINT: Depending on the reception conditions
in your particular area, you may find that the
list of channels found includes one or more
repeated names. This is because the receiver
may detect and store some channels, includ-
ing those it cannot receive clearly, from adja-
cent areas alongside the strong channels from
a transmitter nearby. This is not a problem
and the weaker channels can be deleted from
the receiver later, as described in - Edit PR
List on page 23.
2. When the automatic search has finished,
the EDIT PR LIST menu appears.
If you want to, you can now edit the
programme numbers (PR) using the EDIT
PR LIST function. For details, see Edit PR
List on page 23.
If you do not want to edit programme num-
bers (PR), go to the next step.
3. Press the MENU button.
The EDIT PR LIST menu disappears and the
following message appears.
If you select Yes, Analogue terrestrial broad-
casting AUTOMATIC PROGRAMMING SYSTEM
(A.P.S.) window is displayed.
01-ENG-20710-17MB16P-C1897S UK-(LT-20DJ5SFR)-(TVAVOK)-IDTV-10041701-50088870.p65 05.06.2006, 08:4414