Filter
Top Products
Getting started
XV-511BK [C] EN
LVT0336-003A
16
Getting
started
English
Français
To use the remote control unit for TV operation
You can operate your TV from the remote control unit.
Setting the remote control signal for operating your TV.
1 Holding down TV/VIDEO, enter the manufacturer code of your TV listed below by using the numeric buttons (0 - 9).
Do not release TV/VIDEO. Keep holding it until the next step is completed.
2 Press STOP while holding down TV/VIDEO.
The following buttons can be used for operating the TV:
3 Try to operate your TV by pressing TV POWER.
If your TV turns on or off, you have successfully set the control signal.
Turns the TV on or off.
Changes the TV channels.
Adjusts the TV volume.
Selects the TV channels
(while holding down the SHIFT button).
*For some TVs, pressing "+10" while holding down SHIFT
functions as the "+100," and pressing "10" while holding down
SHIFT functions as the "RETURN" button.
Switches input mode (either TV or VIDEO).
No. Manufacturer
01 JVC
02 MAGNAVOX
03 MITSUBISHI
04 PANASONIC
05 RCA
06 SHARP
07 SONY
08 TOSHIBA
09 ZENITH
10 HITACHI
11 PANASONIC
12 SAMSUNG
13 SANYO
14 SANYO
15 SAMSUNG
Manufacturer code list
• The remote control unit is initially set for operating a JVC TV.
• If there is more than one code listed for the manufacturer of your TV, try them one by one until you succeed.
TV POWER
TV ch
+
–
TV VOL.
+
–
90
to
TV/VIDEO
NOTE
Example:
To enter the manufacturer code "01":
Press "0" then "1."