Filter
Top Products
7
Connecting the Speakers
Connect the satellite speakers and subwoofer to the terminals on the
rear panel using speaker cords supplied.
The ends of the speaker cords are colored to indicate the terminals to
be connected.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Connecting speaker cords to the speakers
• Connect the cord with a gray tube to the red (+) terminal, and the
cord with a black tube to the black (–) terminal respectively.
• You can use the satellite speakers interchangeably for any position
except for subwoofer. Make sure not to connect the subwoofer
terminal and the satellite speaker.
1
Press and hold the terminal clamp.
2
Insert the speaker cord.
3
Release the finger from the clamp.
Notes:
• If the speaker cord is covered with vinyl, remove the vinyl
by twisting it as shown in the diagram.
• Make sure the core wire of speaker cords do not expose
to out of the terminals. This could cause
short-circuit.
Connecting speaker cords to the center unit
Insert the speaker connectors to the speaker
terminals on the rear panel.
• Make sure to match the color of the connector and the terminal.
When setting the speakers
To obtain the best possible sound from this system, you need to
place all the speakers except the subwoofer at the same distance
from the listening position with each front faced toward the listener.
Since bass sound is non-directional, you can place a subwoofer
wherever you like. Normally place it in front of you.
Left front
speaker
Right front
speaker
Right rear
speaker
Subwoofer
Left rear
speaker
Center speaker
If your speakers cannot be placed at the same distance from the
listening position
You can adjust the delay time of the center speaker and rear
speakers. For in-depth information about adjusting the delay time,
see “Adjusting the Sound” on page 17.
Notes:
You can change the phase of subwoofer sounds by connecting the
speaker cords to the terminals inversely—the cord with a gray tube to
the black terminal, and the cord with a black tube to the red terminal.
You may get more effective bass sounds by changing the phase.
CAUTIONS:
• When attaching the satellite speakers on the wall, have them
attached to the wall by a qualified person.
DO NOT attach the satellite speakers on the wall by yourself to
avoid an unexpected damage of their falling from the wall, caused
by incorrect attachment or weakness in the wall.
• Care is required in selecting a location for attaching speakers to the
wall. Injury to personnel, or damage to equipment, may result if the
speakers are attached in a location which interferes with daily
activities.
132
With the Side marked ª and
· upward.
Speaker Connector
01_11_TH_A25[J].p65 03.8.31, 2:08 PM7