Filter
Top Products
29
Basic
operations
Basic Operations
English
Portugés
Chinese
XV-K505GD/XV-K503TN
LET0143-001A
[3U, 4U, US, UB, UT]
(EN)
English
Español
To simulate the surround sound [3D PHONIC]
7 During playback
1
Press
3D PHONIC
.
2
Within 10 seconds, select
the desired effect mode by
pressing
3D PHONIC
.
Each time you press
3D PHONIC
, the
effect mode changes as follows:
* When you play the DVD disc recorded in Dolby Digital and contains more
than 3 channel sound, ACTION does not appears.
3
Press to adjust the
effect level.
You can adjust the effect level in
5 steps.
Toward L : Reduce the effect
Toward H : Enhance the effect
Selected effect mode
Effect level
NOTES
You can select the simulated surround effect depending on the disc contents. If
you connect the unit to your stereo system, you can enhance sound quality and
produce a greater surround effect.
Adjusting the surround sound
ACTION*
DRAMA
THEATER
OFF
THEATER
3D PHONIC
LH
THEATER
LH
3D PHONIC
¶ The sound effect (3D PHONIC) is possible only on discs which are recorded
in DOLBY SURROUND or DOLBY DIGITAL. However, some DOLBY
SURROUND or DOLBY DIGITAL discs do not contain the rear sound signal,
in this case, the setting can be changed but the sound effect cannot be
obtained.
¶ You can change the setting of the discs which do not contain the rear sound
signal, but the sound effect cannot be obtained.
¶ The sound effect is not possible, and will not work even if set when the unit
outputs the DTS or Dolby Digital bitstream signal from the DIGITAL OUT
jack.
¶ The sound effect will not be set or operate, even if
3D PHONIC
is pressed, on the
sound of DVD discs recorded in Linear PCM.
¶ When you set the 3D PHONIC function to on, the DOWN MIX and
COMPRESSION setting in the PREFERENCE 2 display are disabled.
To erase the 3D PHONIC
screen, press
ENTER
. The 3D
PHONIC screen disappears if
there are no operations for
more than 10 seconds.