Filter
Top Products
18
Getting started
XV-K505GD/XV-K503TN
LET0143-001A
[3U, 4U, US, UB, UT]
(EN)
IN
PCM/STREAM
OPTICAL
VIDEO S-VIDEO
AV COMPU LINK
VIDEO OUT
DIGITAL OUT
OPTICAL
DIGITAL
IN
AUDIO
RIGHT
LEFT
LEFT
RIGHT
AUDIO OUT
NTSC
PAL
ON
ATTENUATOR
OFF
To connect to audio equipment with a digital input
Connection to an amplifier/receiver with digital input, Dolby Digital decoder/amplifier with
built-in Dolby Digital decoder, or an amplifier with built-in DTS and Dolby Digital decoder
You can enhance the sound quality by connecting the unit’s DIGITAL OUT (optical) with the digital input of an
amplifier, DAT or MD by using a digital cable. The digital stereo audio signal from a disc is directly transferred. And,
if you connect with a Dolby Digital decoder or an amplifier with built-in Dolby Digital decoder by using an optional
digital cable, you can enjoy high-quality audio and surround sound. The unit also is compatible with the DTS
function. When you make a digital connection, leave the 2 channel analog audio connection as it is. Otherwise,
depending on the disc type, no audio may be reproduced.
¶ DTS (Digital Theater System)
DTS is a newly-developed surround system which can handle more amount of data than Dolby Digital, providing
better audio quality.
Though the number of audio channels is 5.1 which is same as Dolby Digital, DTS provides fat sound and better
signal-to-noise ratio, thanks to the lower audio compression ratio format. It also provides wide dynamic range
and better separation, resulting magnificent sound.
¶ When you connect the audio equipment with a digital input, before using, change the “DIGITAL AUDIO OUTPUT”
setting in the “PREFERENCE 2” on-screen display according to the connected audio equipment with a digital
input. When the “DIGITAL AUDIO OUTPUT” setting is not set correctly, loud noise may be played back from
speakers, and it cause of the breakdown of your speakers. See “DIGITAL AUDIO OUTPUT” on page 52.
¶ With this connection, the unit’s settings for “COMPRESSION” and “DOWN MIX” in the “PREFERENCE 2” on
screen display are invalid. Settings for these items must be made from the decoder.
• For digital connection, connect the unit’s DIGITAL OUT (optical) to the digital input of a Dolby Digital decoder or an
amplifier with built-in Dolby Digital decoder using an optional digital cable.
Audio cable
(not supplied)
The unit
Amplifier/
receiver with
digital input,
Dolby Digital
decoder/amplifier
with built-in
Dolby Digital
decoder, or an
amplifier with
built-in DTS and
Dolby Digital
decoder
Optical digital cable
(not supplied)
WhiteRed
White
Red
NOTES