Filter
Top Products
Getting started
17
Getting started
English
You can enhance the sound quality by connecting either of the unit's DIGITAL OUT jacks to the digital input of an
amplifier, MD, etc. by using an optional digital cable (OPTICAL or COAXIAL). The digital audio signal from a disc is
directly transferred. If you connect the unit to a Dolby Digital or DTS decoder or an amplifier with a built-in decoder by
using an optional digital cable, you can enjoy high-quality surround sound.
When you make the digital connection, we recommend also to make the analog connection, because, depending on
discs, no signal may be output from the DIGITAL OUT.
When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the
unit’s AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The
STANDBY indicator lights and setup is completed.
Warning
• Disconnect the power cord if you are not going to use the unit for a long time.
• Disconnect the power cord before cleaning the unit.
• Disconnect the power cord before moving the unit.
• Do not connect or disconnect the power cord with wet hands.
• Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other
accidents.
Warning
• Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.
• To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If the
cord is damaged, contact a dealer and get the new power cord.
• Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.
To connect to audio equipment with a digital input
NOTES
• When you connect the unit's DIGITAL OUT to digital audio equipment, before using, make the “ DIGITAL AUDIO OUTPUT”
setting in the “ PREFERENCE 2” on-screen display correctly according to the connected audio equipment. If the “ DIGITAL
AUDIO OUTPUT” is not set correctly, loud noise may be generated from speakers, causing damage to them. See “ DIGITAL
AUDIO OUTPUT” on page 46.
• With the digital connection, the “ COMPRESSION” settings in the “ PREFERENCE 2” on-screen display are invalid. Settings for
these items must be made from the decoder.
To connect the power cord
Digital equipment
Audio cable
(not supplied)
White
Red
The unit
White
Red
Coaxial digital cable
(not supplied)
Optical digital cable
(not supplied)
The OPTICAL jack is protected by the hinged cover.
To connect the optical cable to the jack, press the
cover with the plug and connect it to the jack inside
in the correct direction.
AV COMPU LINK
AUDIO
RIGHT
LEFT
IN
OPTICAL
COAXIAL
DIGITAL
IN
VIDEO OUTAUDIO OUTDIGITAL OUT
RIGHT
COMPONENT
S-VIDEO
YP
B
P
R
PCM / STREAM
COAXIALOPTICAL
LEFT
VIDEO
6(1*ERRN3DJH:HGQHVGD\0D\30