Filter
Top Products
19
Installation and connection
Brief instructions for installing the HDP 171
The sequence of pictures shown illustrates all the necessary
installation steps that are required to assemble the HDP 171 turntable
and the BAS 60 planar antenna on the roof of the vehicle.
The other detailed
instructions in this operating
manual must also be
followed!
For ease of illustration, we
have dismantled the BAS 60
on these photographs.
As supplied, the BAS 60
is pre-mounted on the
HDP 171.
Determination of installation
location.
Caution! System has a turning
range of 96 cm (Ø). Drill hole
with Ø 38 mm. Deburr sharp
edges of hole.
Apply Sikafl ex
®
291 adhesive
to roof duct supports. Insert
supports into hole and secure
from below with knurled nuts.
Unscrew screws (x6, SW 10)
in mounting plate and remove
mounting plate.
Place turntable on prepared
support beams to protect the
roof of the vehicle.
Align mounting plate with arrow
in direction of travel. Mark the
six drilling holes for securing the
mounting plate.
Apply Sikafl ex
®
291 adhesive in
a sinuous line between the two
grooves and spread with spatula
or similar. Avoid skin contact!
Place mounting plate on roof
duct and secure with appropriate
screws (choose screws
according to thickness/structure
of roof).
Screw turntable onto mounting
plate using torque wrench.
Caution!
Tightening torque: 6 Nm