Filter
Top Products
Programme selection
the programme is normally scrambled. The required programme can be selected
with the bar cursor and confirmed by pressing the
Obutton.
Radio programme list
See above. The same applies to the radio programme list. Programme selection
This section describes how you select analogue and digital TV programme with
your receiver and how you can set the required volume. This description of the
functions assumes that the receiver has been connected correctly.
If you wish to connect the receiver yourself, please read the section "Connection
and start-up" beforehand.
Selecting a TV programme
Reception status
The following information describes how to select other channels and shows what
the on-screen displays look like.
After switching on the receiver, simply
press the
oubuttons in order to
select other TV programmes in their
ascending or descending order in the
channel memory.
Every time you press the button, an on-screen display shows you the selected pro-
gramme together with the time, the programme start and end times as well as the
programme title in the information box provided these data are transmitted together
with the signal.
By pressing the
Obutton, you can leave
this information box permanently dis-
played or switch it off by pressing the
button once again.
You will receive the "channel scrambled"
message for scrambled channels.
You cannot view a scrambled channel.
However, some broadcasters occasionally
transmit unscrambled programme blocks.
A further option of selecting a different
programme is to press the
ibutton. The
TV channel list is now displayed. In the left
column, it will provide information relating
to the received satellites, the transponder
and its transmission frequency, the
polarisation, the symbol rate and the
scrambling. The programme number, the
programme broadcaster and the type of
reception signal (free to-air/scrambled) is
shown on the right.
With the
oubuttons you jump to the next programme, with the -+buttons
you jump to the neighbouring page or with the buttons on the remote control enter
the programme number (Ch). Confirm your selection by pressing the
Obutton.
Press the
Lbutton to exit the programme list and remain in the already pro-
gramme set.
18