Filter
Top Products
Installation menu
DiSEqC setting
The precondition for this setting is that you have made no changes in the DiSEqC
(UFO) set-up, refer to the section "DiSEqC (UFO) Set-up".
When you are in the LNB configuration menu (see above), press the
ou
buttons to move the coloured bar to the "HotBird" position, press the
- or + button
and by pressing
O confirm that you wish to add a satellite. The transponder data
are now stored and a tick appears after "HotBird" to confirm the setting. You can
now set the DiSEqC signal. It serves the purpose of switching between the two
aligned satellites. Press the
ou buttons to go to the DiSEqC-1 setting.
Set #1 for ASTRA and #2 for HotBird. Both positions are already pre-programmed.
You can pre-program up to four satellites (16 settings: 4x H and V as well as 4x
High and Low).
Press the
L button 4 times to exit the menu. At the same time, the receiver will
confirm that the set parameters have been saved. If a setting is incorrect, you will
see the following message on the screen:
Bad or no signal
With cascaded switches, a total of 16 satellite positions can be stored under DiS-
EqC 2. With H/V as well as High/Low this results in a total of 256 settings. You
should have a specialist carry out these settings and set-up such a system.
Antenna settings
This menu is intended solely for service
purposes and, if need be, i.e. if no
measuring instrument is available, it can
be used to align the antenna (satellite
dish).
The satellite can be defined in the first line
and the transponder in the second.
The polarisation of the received signal and
the transmitted symbol rate are shown in
the next line.
The bar displays provide an indication of the strength (relative level) of the signal
and its quality. However, no conclusions relating to the quality of the antenna sys-
tem or of the cable connection can be derived from this signal.
Satellite search
In the satellite scan menu you can instruct
the receiver to search for channels on the
satellite. Use the
- or + button to select
the required satellite. Start the search by
pressing
O.
If you wish to set your system to a com-
pletely new satellite, you will need to enter
manually at least one known transponder
in order to start the search (see Section
"TP set-up/scan"). You can obtain the necessary information from the correspond-
ing TV and satellite magazines or Internet pages.
37