Filter
Top Products
21
FIRST INSTALLATION: Single-cable system (automatic)
The receiver searches for the transmission channels
on your single-cable system and shows in the next
display the available transmission channels.
Use the
buttons to select the transmission
channel you want and confi rm the selection with the
button.
The receiver now reads the existing system data for
your single-cable system and confi gures itself.
The receiver has been successfully registered
on your single-cable system. Confi rm the display
with the
button. Now press the
$
(green)
button. The receiver will automatically display the
menu for the channel search. Continue with the item
(“Perform channel search”).
If no connection to the single-cable system could be established, you will receive the message
“Registration was abortive!”. Check your settings and if necessary call for expert help.
If one or more receivers are already present on the system and an additional receiver
is to be connected, when assigning the transmission frequency for the new receiver
make sure that no transmission frequencies are duplicated. No frequency can be used
by more than one receiver.
No frequency can be used by more
than one receiver.
The receivers would interfere with
each other.