Filter
Top Products
39
The “Orbit position”, parameter, possible values 1-4, must
be entered for control by DiSEqC
TM
.
DiSEqC™1.0 4 sat. positions 1-4
DiSEqC™1.1 16 x 4 sat. positions (uncommitted
switches) 1-16/Off
As matrix operation switches are required to operate
DiSEqC
TM
1.1, the cabling is highly complicated and should
only be undertaken by an experienced installer!
Enable
{ON} The selected satellite is enabled for your
reception system.
{OFF} The selected satellite is disabled.
5. Uncom.switch - Uncommitted switches in DiSEqC™-
Mode
Uncommitted Switches (US) are used on special satellite
reception systems to pre-select different groups.
In delivery status, the “Uncommitted switches” are
deactivated = OFF.
Note:
Satellites
2. Enter LO1
3. Enter LO2
At the factory LO1 and LO2 are preset to 9,750 MHz and
10,600 MHz.
If the LNB-LO frequencies differ from the factory presets,
enter the relevant values here. Activate with
and use
the number buttons
-
to enter the LO frequencies.
Press
to fi nish.
Please make sure that a digital-capable LNB is installed in
your reception system.
4. Enter orbit position