Filter
Top Products
Preparations
English
17
LANGUAGE
Menu Language
Select a language for the Setup menu and on-screen display.
Disc Audio/ Disc Subtitle/ Disc Menu
Select the language you prefer for the audio Track (disc audio),
subtitles, and the disc menu
Original: Refers to the original language in which the disc was
recorded.
Other: To select another language, press numeric keys then
[ENTER] key to enter the corresponding digit number according
to the language code list (See page 21.). If You enter the wrong
Language code, press the [CLEAR] key.
DISPLAY
TV Output Select
RGB
TV Aspect
4:3: Select when a standard 4:3 TV is connected.
16:9: Select when a 16:9 wide TV is connected.
Display Mode
Display Mode setting works only when the TV Aspect mode is
set to "4:3".
Letterbox: Displays a wide picture with bands on the upper
and lower portions of the screen.
Panscan: Automatically displays the wide Picture on the entire
screen and cuts off the portions that do not fit.
TV Output Select (only for Europe)
Set the player's TV Output Select options according to the TV
connection type.
RGB: When your TV is connected with the SCART jack.
Y Cb Cr: When your TV is connected with the COMPONENT
VIDEO jacks on the DVD player.
AUDIO
Each DVD disc has a variety of audio output options. Set the
player’s AUDIO options according to the type of audio system
you use.
Dolby Digital/ DTS/ MPEG
Bitstream: Select "Bitstream" if you connect the DVD Player’s
DIGITAL OUT jack to an amplifier or other equipment with a
Dolby Digital, DTS or MPEG decoder.
PCM (for Dolby Digital/ MPEG): Select when connected to a
two-channel digital stereo amplifier. DVDs encoded in Dolby
Digital or MPEG will be automatically down mixed to two-
channel PCM audio.
Off (for DTS): If you select “Off'', the DTS signal is not output
through the DIGITAL OUT jack.
Sample Freq. (Frequency)
If your receiver or amplifier is NOT capable of handling 96 kHz
signals, select 48 kHz. When this choice is made, this unit auto-
matically converts any 96 kHz signals to 48 kHz so your system
can decode them.
If your receiver or amplifier is capable of handling 96 kHz sig-
nals, select 96 kHz. When this choice is made, this unit passes
each type of signal through without any further processing.
Check the documentation for your amplifier to verify its capa-
bilities.
When the disc prohibits 96 kHz digital output, the signal always
is put out after down-conversion.
Screen saver
The screen saver appears when you leave the DVD player
in stop mode for about 5 minutes. If the Screen saver is
displayed for 5 minutes, the DVD player automatically turns
itself off.
Continued to next page
3