Kenwood DVF-R9030 DVD Player User Manual


 
Settings
26
Chapter 2: Various Setups
"Digital Audio PCM Down
Conversion" Setting
The player can output digital signal with maximum
sampling rate of 96 kHz from the digital audio output
connector. When a DVD disc recorded in high
sampling rate PCM is played, this setting makes it
possible to select whether the signal is converted into
48 kHz signal or 44.1 kHz/16-bit signal.
At the factory, the player has been set to "On" for AV
amplifiers incompatible with high sampling rate
digital signal connection. If the connected AV amplifier
is compatible with 96 kHz digital input, change the
setting to "Off".
Setting items
" " : Select to return to the previous screen.
"On" : Select to down-convert the signal to 44.1
kHz/16-bit PCM signal. Select this setting when
the connected AV amplifier is incompatible with
96 kHz digital input.
The analog output signals are also converted
accordingly.
"Off" : Select to skip down conversion. Select this
setting when the connected AV amplifier is
compatible with 96 kHz digital input. However,
if the disc inhibits the 96 kHz digital output,
the signal is down-converted even when this
setting is selected.
With DVD AUDIO discs, the signal is always
output after down sampling conversion.
Operation procedure
1.
Set the mode switch of the joystick remote to the
Purple position.
2. While the player is in stop mode, press
SET UP
1
and
tilt the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3. Press
ENTER
to open the setup screen.
4. In the setup menu, select "Digital Audio PCM
Down Conversion" by tilting the joystick up or
down and press
ENTER
.
7
7
On
7
Off
Digital Audio
Dolby Digital
Speaker Setting
Audio During Search
Dynamic Range Control
Audio Filter
DTS
MPEG
PCM Down Conversion
5. Select "On" or "Off" by tilting the joystick up or
down, then press
ENTER
to enter the selection in
memory.
"Digital Audio Dolby Digital"
Setting
When a DVD recorded in Dolby Digital is played, this
setting makes it possible to select the audio signal from
the digital output connector of the player.
At the factory, the player has been set to "Bitstream" to
enable digital connection to an AV amplifier with built-
in Dolby Digital decoder. Change the setting to "PCM"
when the digitally connected amplifier does not
incorporate the decoder.
Setting items
"
" : Select to return to the previous screen.
"Bitstream" : The signal is output as a bitstream.
Select when connecting a component containing
Dolby Digital decoder.
"PCM" : The signal is converted onto 48 kHz
(2CH.) PCM signal before being output. Select
when connecting a component without Dolby
Digital decoder.
"SOUND" Setting