Filter
Top Products
r
*,a “>.
(,,,,,,,,,, ,,,,e, f&;,,*
Units are designed for operation as follows.
U.S.A. and Canada
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 120V only
Australia
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 240 V only
For the United Kingdom
*For other countries
Factory fitted moulded mains plug AC voltage selection
I. The mains plug contains a fuse. For replacement, use
only a 13-Amp ASTA-approved (BS 1362) fuse.
2. The fuse cover must be refitted when replacing the
fuse in the moulded plug.
3. Do not cut off the mains plug from this equipment. If
the plug fitted is not suitable for the power points in
your home or the cable is too short to reach, a power
point, then obtain an appropriate safety approved
extension lead or adapter, or consult your dealer. If
nonetheless the mains plug is cut off, remove the
fuse and dispose of the plug immediately, to avoid a
possible shock hazard by inadvertent connection to
the mains supply.
IMPORTANT:
The AC voltage selector switch on the rear panel is set
to the voltage that prevails in the area to which the unit
is shipped. Before connecting the powercord to your AC
outlet, make sure that the setting position of this switch
matches your line voltage. If not, it must be set to your
voltage in accordance with the following direction.
4C voltage selector switch
The wires in the mains lead are coloured in accordance
with the following code:
Blue : Neutral
Brown : Live
Move switch lever to match your lbne voltage with
a small screwdnver or other nolnted tool.
Vote:
Do not connect those leads to the earth terminal of a
three-pin plug.
Xrwarrantydoesnotcoverdamagecausedbyexcessive
ine voltage due to improper setting of the AC voltage
<elector switch.
Europe and U.K. ,..........,,.,...,.....,............,....,,.......,.,...... AC 23011 only
*Other countries ,....,..,,.......,.. AC 1 IO- 120/220-240 V s witchable
a&ions
A Caution : Read this page carefully to ensure safe operation.
“~~~##~~\~\$ I_^ I_ ~~~*~“<q““” ,,,,,, em;<7 ,, ;
,, ,, ,,,,____,,,,,,,,,,,, ;,, . .,.:,, .__ ,.i”, ,,
i <,i
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
a
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRI-
ANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DAN-
GEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT
MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT
THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SER-
VICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
The marking of products using lasers
(Except for some areas)
The marking this product has been classified as Class
1. It means that there is no danger of hazardous radia-
tion outside the product.
Location: Back panel