Filter
Top Products
— 33 —
SOLUTIONPOSSIBLE CAUSEPROBLEM
The sound skips. Something is touching the disc changer. Remove whatever is touching it.
The CD is scratched or dirty. If skipping happens at the same place when the car is
stopped, something is wrong with the CD. Clean the CD.
The computer chip in the unit is not functioning normally. Press the reset button on the unit (see page 4).
The display shows that the
changer is being played, but no
sound can be heard.
The specified track does not
play.
Random play or magazine random play has been
selected.
Turn off the random play or magazine random play
function.
If the following situations, consult your nearest service centre:
• Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX" showing in the display during the Changer
Mode.
• Even though no device (KCA-S210A, CA-C1AX,KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected,
the AUX Mode is entered when switching modes.
"AUX" is displayed without
achieving External disc control
mode.
O-N switch is set to "O" side. Set the switch to "N" side.
Unsupported disc changer is connected. Connect the supported disc changer. (see page 3)
Can’t remove disc. The cause is that more than 10 minutes has elapsed
since the vehicle ACC switch was turned OFF.
The disc can only be removed within 10 minutes of the
ACC switch being turned OFF. If more than 10 minutes
has elapsed, turn the ACC switch ON again and press
the Eject button.
Track repeat, disc repeat, track
scan, random play, and
magazine random play start by
themselves.
The setting is not canceled. The settings for these functions remain on until the
setting to off or the disc ejected, even if the power is
turned off or the source changed.
Cannot play CD-R or CD-RW Finalization processing is not being conducted for CD-
R/CD-RW.
Conduct finalization processing with CD recorder.
A non-compatible CD changer is being used to play the
CD-R/CD-RW.
Use a CD changer compatible with CD-R/CD-RW to play.