Filter
Top Products
Page 9
11. Run wiring from the back of the dome unit to the roof edge, then along edge to location
where wiring will be fed into the vehicle. (If installing an optional auxiliary receiver, run
auxiliary coax (not supplied) to location where it will enter the vehicle.) Secure wiring to roof
every 12-18 inches (Fig. 9).
12. Drill 3/4” hole for the wiring through the roof and into the cabinet where receiver is stored.
Feed wiring down through hole. Seal opening with roof compatible sealant so that it is
completely waterproof (inside and outside of the hole). Repeat for auxiliary coax if present.
13. Fasten cable entry cover to roof. Seal mounting holes, perimeter of cover and cable opening
so they are completely waterproof.
Fig. 9
14. Remove blue protective sheet and red “position to rear” sticker from the dome unit.
TYPICAL ROOF INSTALLATION - OVERHEAD VIEW
IMPORTANT!
Sealant must be roof compatible.
IMPORTANT! Installer is responsible for determining proper roof compatible fasteners for cable entry cover.
Roof hole for wiring must be sealed so it is completely waterproof. Mounting holes, perimeter
of cable entry cover and cable opening of cable entry cover must be sealed so they are
completely waterproof. SEALANT MUST BE ROOF COMPATIBLE.