Filter
Top Products
BELL TV ANTENNA CONFIGURATION
Bell TV Standard Digital 91 (satellite 91)
1. On the King-Dome controller, press and release the
ON button. Wait for the status light to flash orange,
and then W
AIT 4 MORE SECONDS.
2. Press and release the ON button 8 times.
The status light starts rapidly flashing green and red.
3. Press and hold the button for 4 seconds.
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure your
receiver for mobile use.
To configure your receiver, GO TO PAGE 29 AND RUN THE CHECK SWITCH.
Page 22
DISH HD Alternate with Locals (satellites 61.5, 110, 119)
1. On the King-Dome controller, press and release the
ON button. Wait for the status light to flash orange,
and then W
AIT 4 MORE SECONDS.
2. Press and release the ON button 16 times.
The status light starts rapidly flashing green and red.
3. Press and hold the button for 4 seconds.
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure your
receiver for mobile use.
To configure your receiver, GO TO PAGE 29 AND RUN THE CHECK SWITCH.