Filter
Top Products
8 VA-4H - Operating the VA-4H
6 Operating the VA-4H
To set the EDID source for each channel as illustrated in the example in Figure 3:
1. Press and hold the CAPTURE pushbutton. The indicator LEDS illuminate in
a cycle as follows:
MONITOR, lower green LED
DEFAULT, upper red LED
PASS, both LEDS together.
2. Release the pushbutton at the desired setting.
The setting is saved in non-volatile memory.
Notes:
• DEFAULT and MONITOR settings do not support HDCP key exchange.
For the display to work properly with HDCP encryption, the VA-4H must be
set to PASS
• If an EDID is captured the MONITOR LED flashes slowly
• If an EDID is not captured, the DEFAULT LED flashes quickly and the
default EDID is loaded
• When exchanging a display, refresh the source by disconnecting and
reconnecting the HDMI cable between the source and the device input