Filter
Top Products
QUESTIONS AND ANSWERS
Q. Do I have to switch the Sampling Frequency when I go between
my CD and DAT?
A. No. Your STUDIO 2 automatically senses the input frequency
and does all necessary switching.
Q. I am not getting any sound through the Processor. What could
be wrong?
A. Most likely there has been a simple mistake in installation.
Check all connections IN and OUT of the Processor. Is the digital
source component powered? Check all power connections. Have
you selected the correct source on the STUDIO 2 and preamp?
Check the front panel LED’s for power supply stability. If you still
have no sound, turn off the power and contact your dealer.
Q. I have some very fine audiophile interconnect.cable which has
superior sonic characteristics. Can I use this for my coaxial digital
input?
A. You may experiment with any high quality cable. Do note that
most audio interconnect cable is not designed to carry the ultra-
high frequency information of the digital bit stream.
NOTE: For the STUDIO 2, we recommend non-capacitive coaxial
cable which has a bandwidth in excess of 10MHz and excellent
shielding properties.
PAGE 16